Control 4 C4-TSWMC5-EG-WH Installation Manual

5" and 7" In-Wall
Touch Screen Wall Box

Installation Guide

New Construction
Supported Touch Screen Models
• C4-TSWMC5-EG-WH - 5" In-Wall Touch Screen,
White
• C4-TSWMC5-EG-BL – 5" In-Wall Touch Screen,
Black
• C4-TSWMC7-EG-WH – 7" In-Wall Touch Screen,
White
• C4-TSWMC7-EG-BL – 7" In-Wall Touch Screen,
Black
Supported Wall Box Models
Plastic Model
(C4-NWB57C-P)

General Description

This Control4® kit provides a wall box to
accommodate the installation of a 5" and 7" In-
Wall Touch Screen. The kit is intended for new
construction where drywall is not yet in place.
™
Metal Model
(C4-NWB57C-M)
Along with the wall box, the kit contains a stud
plate for attachment to a wall stud prior to drywall
installation.
Note: If the drywall is in place, use one of
the kits intended for retrofit (models C4-
RWB57C-P or C4-RWB57C-M).
Requirements
• Tools to install the wall box, such as a tape
measure, a pencil, a hammer or screwdriver
(depending on whether you are using screws
or nails), a drywall saw, a utility knife and other
common drywall tools.
• A 5/16" nut driver or socket wrench, if using the
metal wall box.
• Nails or screws (4 to 6).
What's in the Kit
• 5" and 7" In-Wall Touch Screen Wall Box for New
Construction
• Two (2) ferrite clamps with a rectangular
enclosure and one ferrite (1) clamp with a round
enclosure
• 5" and 7" In-Wall Touch Screen Wall Box New
Construction Installation Guide (this document)

Specifications

Plastic Wall Box Model:
1 Stud plate
2
Wall box (New Construction)
3
Dovetail socket (on both sides to reverse
position)
2
3
1