Control 4 C4-TSWMC5-EG-WH Installation Manual page 2

5" and 7" In-Wall
Touch Screen Wall Box
Installation Guide
New Construction
Metal Wall Box Model:
1 Mounting location (on both sides to reverse
position)
2 Wall box (New Construction)
3
Stud plate
1
Installation
Note: This kit is intended for installation of
a wall box prior to drywall installation. If the
drywall is already in place, use the retrofit
installation kit (C4-RWB57C-P or
C4-RWB57C-M).
Notes: (1) Install the wall box flush with the
wall. (2) Wall box dimensions: (H x W x D): 2.7"
x 4.1" x 2.4" (68mm x 104mm x 61mm).
1 Find an appropriate wall box location for the
Touch Screen you are installing:
• The wall box should be in a convenient location,
for example, near the entrance of a room.
• The wall box should be at eye level,
approximately 57 to 61 inches from the floor.
™
3
2
• When using the Ethernet models near a location
where an Ethernet CAT5 cable is pulled.
• When using the wireless model above or near an
AC power source, such as an AC outlet.
2
Hold the wall box and stud plate against the
nearest stud, and mark the correct position
according to your choices in Step 1. Follow these
guidelines.
a
Place the wall box so that, when mounted, it
will be flush with the surface of the drywall
after the drywall is installed. For example, if
the drywall is 3/8 of an inch deep, the front
rim of the wall box must be 3/8 of an inch
above the wall stud (toward you).
IMPORTANT! Make sure the wall box is flush
with the wall after the drywall is installed.
Allow 3/8 of an inch before the drywall is
installed (depending on the thickness of the
drywall), and err toward 5/16's of an inch for
the best fit.
b Install the wall box according to the arrows
inside the box that indicate the correct side
up.
IMPORTANT! For safety reasons, install the
wall box with the correct side up so the Touch
Screen interlocks with the wall box, allowing
a barrier to separate high-voltage from low-
voltage circuits.
c Install the wall box with the stud plate on
either the right or the left side, depending
on which wall stud you choose. You may
detach the stud plate from the wall box on
one side and reattach it on the opposite side
if needed.
3 Detach the stud plate from the wall box.
New Device
AC Outlet
(unless using PoE)