Description Of Controls - Maytag MAF 1260 Instructions For Use Manual

Description of controls

Fig. 1
L
P
C D E F G
Door handle
"Door Locked" indicator light
"Start/Pause" button
"Pre Wash" button
"Express Wash" button
"Extra Rinse" button
"Fast Iron" button
Wash control temperature knob
Buttons indicator light
Time countdown system indicator lights
Timer knob for wash programmes with "OFF" position
Detergent drawer
M
B
I
N
A
A
B
C
D
E
F
G
I
L
M
N
P
6
Door handle
Press the finger-bar inside the door handle to open the door.
DOOR LOCKED indicator light
The "Door Locked" indicator light is illuminated when the door is fully closed and the
machine is ON.
When the "Start/Pause" button is pressed on the machine with the door closed the indicator
will flash momentarily and then illuminate.
If the door is not closed the indicator will continue to flash.
A special safety device prevents the door from being opened immediately after the end of the
cycle. Wait for 2 minutes after the wash cycle has finished and the "Door Locked" light has
gone out before opening the door. At the end of cycle turn the programme selector to "OFF".
START/PAUSE button
When a programme is selected, wait for the "END"
indicator light to flash before pressing the "Start/Pause"
button.
Press to start the selected cycle (according to the selected cycle one indicator light will go on).
Note: When the "Start/Pause" button has been pressed,
the appliance can take a few seconds before it starts
working.
Changing the settings after the programme has started (PAUSE)
The programme may be paused at any time during the wash cycle by holding down the
"Start/Pause" button for about two seconds. When the machine is in the paused mode, the
"COUNTDOWN" indicator and option buttons will flash.
To restart the programme, press the "Start/Pause" button once again.
If you wish to add or remove items during washing, wait 2 minutes until the safety device
unlocks the door.
When you have carried out the manoeuvre, close the door, press the "Start/Pause" button
and the appliance will continue working where it left off.
CANCELLING THE PROGRAMME
To cancel the programme, the programme selector should be rotated to the "OFF" position.
7
A
B
C