Complete Installation; Break-In Period; Controls Troubleshooting - Maytag MXS20 Installation Instructions Manual

Complete Installation

1. Soft-Mount Models: Be sure that the shipping brackets are
removed.
2. Rigid-Mount Models: Verify that the washer is properly bolted
in place.
3. Remove the film covering from the cabinet.
4. Open door and make sure that the washer drum is empty.
5. Verify that washer is level and does not rock from
side-to-side.
6. Check electrical connection and ground – PE or PEN.
7. Check drain connection and clearance.
8. Turn power on at circuit breaker.
9. PN Models: Begin wash cycle. Activate the emergency stop
switch. All electrical power to the washer should be deactivated.

Break-In Period

The following checks and adjustments should be performed during
the break-in period as follows:
24 operation hours
Check belt tightness. See "Belt Inspection and Adjustment"
■
in Maintenance.
80 operation hours
Check belt tightness. See "Belt Inspection and Adjustment"
■
in Maintenance.
Check mounting bolt tightness. Retighten if necessary (secured
■
installation only).

Controls Troubleshooting

For programming and controls troubleshooting, refer to the
Programming Guide.
15