GE AJ806L Use And Care Manual page 5

FOY Nlorlnal coo~ing
1. Set Selector Switch at HIGH
COOLO
2. Set Thermostat Control at
desirednumber(usutiy themidpoint
is a good starting position). If room
temperature is not satisfactoryafter
a reasonabletime,setthetemperature
control at a higher number for a
cooler room or at a lower number
for a warmer room.
ForNlaxin%unl cooling
1. Set Selector Switch at HIGH
COOL.
2. Set ThermostatControlat 10.
3. Set VentilationControl at
CLOSE position.
4, Shift Fan Switch to CONT.
For
Q%}ieter
operation
1. Set Selector Switch at LOW
COOL.
2. Set Thermostat Control at
desired number.
3. Set VentilationControl at
CLOSE position.
4. Shift Fan Switch to desired
position—CONT or ~CLE.
During the cooler evening hours,
it is recommended that you set the
Selector Switch at LOW COOL
for very quiet operation and the
Thermostat Control at mid-range
(5 or 6).
WhcrI the Thermostat ControI is set
orI9 or 10and the Fan is set on low
speed, moisture may freeze on the
coils and prevent the unit from
cooling. If this happens, set the
i~tinat high speed and set the
"~hcrlllostatControl to a lower
IIumt~er.
Wor Extrenle 'remperatMr&:J
For greatest economyand best
performance, we suggestyou
alwaysset the SelectorSwitch at
HIGH COOL in extremelyhot
weather.
For air Circula$ioll al%d
filtering without cooling
Set Selector Switchat HIGH FAN
or LOW FAN.
Forfan only operation, the Fan
Switch located behind thefroizt
grille fi~ee p age 4) must be in the
CONT position.
For ventilation
Whether controlsare set for cooling
or fan only operation, setting
VentilationControl at OPEN lets
room air be exhaustedto the
outside. This is helpful in removing
stale air, smoke or odors from the
room, and permits outdoor air to
enter throughnormalopeningsin the
house.However, c oolingeffectiveness
is reduced when this control is set
at OPEN, so we suggestyou don't
keep it there long—especiallyin
hot, humid weather.
'To Adj3Rst Iiir
Directi{}n
*
[Jp"and"down
air
d irection:
Adjustlouverswith your fingertips
to direct dischargedair up, down or
straightahead.
\
Side-to-side air direction: Adjust
louvers with your fingertipsto
direct discharged air to the left, to
the right or straightahead.