Table of Contents
Advertisement
Installation
Operating manual 969 - 00.0 - 08/2014
7.9 Lubrication
WARNING
Skin damage due to contact with oil.
Oil can cause a rash if it comes into contact with
skin.
Avoid any skin contact with the oil.
If oil gets on your skin, wash the affected areas
thoroughly.
All rope and felt bits of the upper section are soaked in oil at the
factory.
Fig. 55: Oil level indicator
MAX
MIN
1. Fill oil through the filler hole (1) to a maximum of 2 mm below
the maximum level mark (2).
ATTENTION
Machine damage possible due to incorrect oil level.
Too little or too much oil can damage the machine.
During initial filling, only pour in oil up to 2 mm below the
maximum level mark.
Required oil:
The machine should only be filled with DA 10 lubricating oil or
equivalent, with the following properties:
•
Viscosity at 40 °C: 10 mm²/s
•
Flash point: 150 °C
①
②
③
(1) - Filler opening
(2) - Maximum level marking
(3) - Minimum level marking
99
Advertisement
Table of Contents
