Table of Contents
Advertisement
34
Manual needle positioning
Manual needle positioning is primarily intended for machine setup.
WARNING
Risk of injury from needle and moving parts.
Switch off the machine before manually positioning
the needle so that it cannot accidentally start during
the positioning procedure.
1. Raise the presser foot using the hand lever and remove any
material so the machine can run out.
2. Turn the handwheel (6) until the needle is correctly positioned.
Important: The correct direction of rotation is marked from
the back by an arrow on the belt cover (5).
Semi-automatic needle positioning
Works when the machine is on by using the electronic handwheel
(1) and is used to power the machine while the operating pedal
(4) is released.
Turning the electronic handwheel drives the machine using
the motor's torque. This allows you, e. g., to sew a seam to the
desired position without the risk of going too far.
1. Switch on the machine at the main switch.
Important: The electronic handwheel is not immediately acti-
vated once the machine is turned on. Therefore:
2. Activate the electronic handwheel (1) either with a one-quarter
turn or by briefly pressing the operating pedal forwards.
3. Turn the electronic handwheel (1) until the needle is correctly
positioned.
Operating manual 969 - 00.0 - 08/2014
Operation
Advertisement
Table of Contents
