Table of Contents
Advertisement
Installation
Operating manual 969 - 00.0 - 08/2014
WARNING
Risk of crushing
Loosening the screws on the lower frame bars can
result in the table plate collapsing under its own
weight. This is more likely if the upper machine
section has already been mounted.
Make sure your hand does not get crushed while
loosening the screws.
1. Loosen the adjustment screws (2) on the frame bars.
2. Set the table plate (1) to the desired height.
Important: Use a tape measure to make sure the table plate
is level.
3. Tighten the screws (2) on the frame bars.
4. Set pedal (3) so that the middle is directly in line with the
needle – Mounting the frame on the table plate and
mounting the pedal, page 83.
5. Use the pedal connecting rod (4) couplings to set the angle as
desired by the machine operator.
85
Advertisement
Table of Contents
