DURKOPP ADLER 969 ECO Operating Manual page 47

Operation
Operating manual 969 - 00.0 - 08/2014
6. Press the pedal to position (–2).
 Thread is cut and presser foot rises.
7. Release the pedal to position (0).
 Presser foot remains raised until another seam is started.
Operating mode: Presser foot rises automatically every
time the machine stops.
1. Press both presser foot position keys on the OP1000 control
panel (4).
 Their signal diodes light up – see  Operating manualfor
Basic/Classic DAC control panel. Presser foot rises.
2. Press the pedal (3) to position (+1).
 Presser foot lowers and machine starts up.
3. Release the pedal to position (0).
 Machine stops and presser foot automatically rises.
4. Press the pedal to position (+1).
 Presser foot lowers and machine starts up.
5. Press the pedal to position (-2).
 Thread is cut and presser foot rises.
6. Release the pedal to position (0).
 Presser foot remains raised until another seam is started.
There is a time delay between starting the presser foot and the
machine starting in order to ensure the material is pressed by the
presser foot by the time sewing begins. This delay can be set
using operating parameters – see  Operating manual for Basic/
Classic DAC control panel.
45