Maintenance Page Definitions - Grandstream Networks GXP2130 Administration Manual

Layer 3 QoS for RTP
Layer 2 QoS
802.1Q/VLAN Tag
Layer 2 QoS 802.1p
Priority Value
PC Port Mode
PC Port VLAN Tag
PC Port Priority Value
Enable LLDP

MAINTENANCE PAGE DEFINITIONS

Maintenance  Web Access
User Password
Confirm Password
Current Admin Password
New Password
Confirm Password
Maintenance  Upgrade and Provisioning
Firmware Upgrade and
Provisioning
XML Config File
Password
HTTP/HTTPS User
Name
GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.5.18
Precedence, Diff-Serv or MPLS. The default value is 26.
Defines the Layer 3 QoS parameter for RTP. This value is used for IP
Precedence, Diff-Serv or MPLS. The default value is 46.
Assigns the VLAN Tag of the Layer 2 QoS packets. The default value is 0.
Assigns the priority value of the Layer2 QoS packets. The default value is 0.
Configures the PC port mode. When set to "Mirrored", the traffic in the LAN
port will go through PC port as well and packets can be captured by
connecting a PC to the PC port. The default setting is "Enabled".
Assigns the VLAN Tag of the PC port. The default value is "0".
Assigns the priority value of the PC port. The default value is "0".
Control the LLDP (Link Layer Discovery Protocol) service. The default setting
is "Enabled".
Table 11: Maintenance Page Definitions
Set new password for web GUI access as User. This field is case sensitive.
Enter the new User password again to confirm.
The current admin password is required for setting a new admin password.
Set new password for web GUI access as Admin. This field is case
sensitive.
Enter the new Admin password again to confirm.
Specifies how firmware upgrading and provisioning request to be sent:
Always Check for New Firmware, Check New Firmware only when F/W
pre/suffix changes, Always Skip the Firmware Check. The default setting is
"Always Check for New Firmware".
The password for encrypting the XML configuration file using OpenSSL.
This is required for the phone to decrypt the encrypted XML configuration
file.
The user name for the HTTP/HTTPS server.
GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE
Page 56 of 87