Grandstream Networks GXP2130 Administration Manual page 35

Reregister Before
Expiration
Local SIP Port
SIP Registration Failure
Retry Wait Time
SIP T1 Timeout
SIP T2 Timeout
SIP Transport
SIP URI Scheme when
using TLS
Use Actual Ephemeral
Port in Contact with
TCP/TLS
Remove OBP from route
Support SIP Instance ID
SUBSCRIBE for MWI
SUBSCRIBE for
Registration
Enable 100rel
GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.5.18
maximum value is 64800 minutes (about 45 days).
Specifies the time frequency (in seconds) that the phone sends
re-registration request before the Register Expiration. The default value is 0.
Defines the local SIP port used to listen and transmit. The default value is
5060 for Account 1, 5062 for Account 2, 5064 for Account 3, 5066 for Account
4, 5068 for Account 5, 5070 for Account 6. The valid range is from 1 to 65535.
Specifies the interval to retry registration if the process is failed. The valid
range is 1 to 3600. The default value is 20 seconds.
SIP T1 Timeout is an estimate of the round trip time of transactions between a
client and server. If no response is received the timeout is increased, and
request re-transmit retries would continue until a maximum amount of time
define by T2. The default setting is 0.5 seconds.
SIP T2 Timeout is the maximum retransmit time of any SIP request messages
(excluding the INVITE message). The re-transmitting and doubling of T1
continues until it reaches the T2 value. The default setting is 4 seconds.
Determines the network protocol used for the SIP transport. Users can choose
from TCP, UDP and TLS. The default setting is "UDP".
Specifies if "sip" or "sips" will be used when TLS/TCP is selected for SIP
Transport. The default setting is "sips".
This option is used to control the port information in the Via header and Contact
header. If set to No, these port numbers will use the permanent listening port on
the phone. Otherwise, they will use the ephemeral port for the particular
connection. The default setting is "No".
Configures to remove outbound proxy from route. This is used for the SIP
Extension to notify the SIP server that the device is behind a NAT/Firewall.
The default setting is "No".
Defines whether SIP Instance ID is supported or not. The default setting is
"Yes".
When set to "Yes", a SUBSCRIBE for Message Waiting Indication will be sent
periodically. The phone supports synchronized and non-synchronized MWI.
The default setting is "No".
When set to "Yes", a SUBSCRIBE for Registration will be sent out periodically.
The default setting is "No".
The use of the PRACK (Provisional Acknowledgment) method enables
reliability to SIP provisional responses (1xx series). This is very important in
order to support PSTN internetworking. To invoke a reliable provisional
response, the 100rel tag is appended to the value of the required header of the
GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE
Page 33 of 87