Grandstream Networks GXP2130 Administration Manual page 40

G.726-32 Packing Mode
Jitter Buffer Type
Jitter Buffer Length
Account x  Call Settings
Early Dial
Dial Plan Prefix
Dial Plan
GXP2130/GXP2140/GXP2160
FIRMWARE VERSION 1.0.5.18
influence the audio quality. The default setting is 2.
Selects "ITU" or "IETF" for G726-32 packing mode. The default setting is
"ITU".
Selects either Fixed or Adaptive for jitter buffer type, based on network
conditions. The default setting is "Adaptive".
Selects jitter buffer length from 100ms to 800ms, based on network conditions.
The default setting is "300ms".
Selects whether or not to enable early dial. If it's set to "Yes", the SIP proxy
must support 484 response. Early Dial means that the phone sends for each
pressed digit a SIP INVITE message to SIP server. SIP server looks into its
extensions and, if no match happened yet, it sends back a "484 Address
Incomplete" message. Otherwise, it executes the action. The default setting is
"No".
Configures the prefix to be added to each dialed number.
A dial plan establishes the expected number and pattern of digits for a
telephone number. This parameter configures the allowed dial plan for the
phone.
Dial Plan Rules:
1. Accepted Digits: 1,2,3,4,5,6,7,8,9,0 , *, #, A,a,B,b,C,c,D,d;
2. Grammar: x - any digit from 0-9;
a) xx+ - at least 2 digit numbers
b) xx - only 2 digit numbers
c) ^ - exclude
d) [3-5] - any digit of 3, 4, or 5
e) [147] - any digit of 1, 4, or 7
f) <2=011> - replace digit 2 with 011 when dialing
g) | - the OR operand

Example 1: {[369]11 | 1617xxxxxxx}
Allow 311, 611, and 911 or any 10 digit numbers with leading digits 1617;

Example 2: {^1900x+ | <=1617>xxxxxxx}
Block any number of leading digits 1900 or add prefix 1617 for any dialed 7
digit numbers;

Example 3: {1xxx[2-9]xxxxxx | <2=011>x+}
Allows any number with leading digit 1 followed by a 3 digit number, followed
GXP2130/GXP2140/GXP2160
ADMINISTRATION GUIDE
Page 38 of 87