HP EliteOne 800 G1 Maintenance & Service Manual page 133

Table 6-5 Computer Setup—Advanced (for advanced users) (continued)
Device Options
Allows you to set:
●
●
●
●
●
●
●
VGA Configuration Displayed only if there is an add-in video card in the system. Allows you to specify which VGA
controller will be the "boot" or primary VGA controller.
Management Allows you to set:
Operations
●
●
●
●
Option ROM Launch (Windows 8 only). Windows 8 installs as a UEFI operating system (as opposed to 'legacy'), and
Policy ships with the 'Legacy Support' setting off in the BIOS. When 'Legacy Support' is off, the Option
ROM Launch Policies are set to 'UEFI Only'. These policies control whether the Legacy Option ROM
or the UEFI driver is loaded for the following features:
●
●
●
Turbo Mode (enable/disable). Allows you to enable and disable the Intel Turbo Mode feature,
which allows one core of the system to run at a higher than standard frequency and power if
other cores are idle. Default is enabled.
Num Lock State at Power-On (off/on). Default is off.
LVDS Panel Select (Auto-select, LG, Samsung). Use this option to select the display panel
manufacturer. When you change the LVDS setting to the installed panel type, the BIOS
reprograms the EDID with the correct data. You must set the panel before the Auto-select
setting functions correctly.
Internal Speaker (does not affect external speakers). Default is enabled.
USB 3.0 BIOS Driver Support (enabled/disabled). Default is disabled.
Multi-Processor (enable/disable). Use this option to disable multi-processor support under the
OS. Default is enabled.
USB Charging Port (enable/disable). Use this option to disable the USB charging port.
AMT (enable/disable). Allows you to enable or disable functions of the embedded
Management Engine (ME) such as Active Management Technology (AMT). If set to disable, the
Management Engine is set to a temporarily disabled state and will not provide functions
beyond necessary system configuration. Default is enabled.
Unconfigure AMT/ME (enable/disable). Allows you to unconfigure any provisioned
management settings for AMT. The AMT settings are restored to factory defaults. This feature
should be used with caution as AMT will not be able to provide any set AMT management
functions once unconfigured. Default is disabled.
Hide Unconfigure ME Confirmation Prompt (enable/disable). Allows you to set the system to
not display the confirmation to unconfigure ME.
Watchdog Timer (enable/disable). Allows you to set amount of time for a operating system
and BIOS watchdog alert to be sent if the timers are not deactivated. BIOS watchdog is
deactivated by BIOS and would indicate that a halt occurred during execution if the alert is
sent to the management console. An operating system alert is deactivated by the operating
system image and would indicate that a hang occurred during its initialization. Default is
enabled.
PXE Option ROMs (UEFI Only/Do Not Launch). Specifies whether the legacy option ROM or
the UEFI driver in the BIOS is used to provide PXE services.
Storage Option ROMs (UEFI Only/Do Not Launch). Specifies whether the legacy option ROM
or the UEFI driver in the BIOS is used to provide RAID setup and support.
Video Option ROMs (UEFI Only/Do Not Launch). Specifies whether the legacy VBIOS or the
UEFI driver in the BIOS is used to provide graphics setup and support.
Computer Setup (F10) Utilities
123