PRESONUS StudioLive CS18AI Owner's Manual page 44

5 Controlling StudioLive RM-series Mixers with the CS18AI
5.3 Processing Signals with the Fat Channel
Equalizer
Limiter Threshold sets the threshold of the limiter for the selected channel or
output bus. When the signal's amplitude (level) exceeds the threshold setting, the
limiter is engaged. Turning the knob counterclockwise lowers the threshold so
limiting begins at a lower amplitude. The threshold can be set from -28 to 0 dB.
Editing for the equalizer is deeper than for the other Fat Channel sections. There are
four Fat Channel controls in the Equalizer section, one for each of the four bands in
the equalizer. These controls can be switched between adjusting frequency, gain,
or Q for the indicated band. The meters show the values for the chosen settings.
Equalizer On globally switches all EQ bands on or off for the selected
input channel or output bus. The corresponding button will illuminate
to indicate that the equalizer band has been enabled.
EQ Low, Low-Mid, High-Mid, and High set the gain, frequency,
or Q for the associated EQ band. By default it controls the gain.
Use the Gain, Freq, and Q buttons in the EQ touchscreen to toggle
the parameter being set using this encoder and meter.
StudioLive CS18AI
™
Owner's Manual
40