Making Drinks With Milk; Filling And Attaching The Milk Container; Making Cappuccino; Making Macchiato - DèLonghi ESAM6600 Instructions For Use Manual

Please note!
if you use pre-ground coffee, you can only make one cup of
coffee at a time.
1. Press the button (fig. 2) repeatedly until "ready
Pre-ground" flashes on the display.
2. Put one level measure of pre-ground coffee into the
funnel (fig. 13).
3. Place a cup under the coffee spouts.
4. Press the 1 cup or
5. Preparation begins.
after using the machine with pre-ground coffee, to go back to
making coffee using beans, deactivate the pre-ground coffee
function by pressing the
coffee mill.

MAKING DRINKS WITH MIlK

Please note!
a few seconds may elapse between energy saving mode and
delivery of the first drink.

Filling and attaching the milk container

1. Turn the lid of the milk container clockwise until it
becomes noticeably difficult to turn, then remove (fig.
14).
2. Fill the milk container with a sufficient quantity of milk,
not exceeding the MAX level marked on the handle (fig.
15).
Please note!
• For a denser more even froth, you must use skimmed
or partially skimmed milk at refrigerator temperature
(about 5°C). To avoid producing milk with poor froth or
large bubbles, always clean the milk container lid and hot
water nozzle as dPribed in the section "Cleaning the milk
container" and "Cleaning the hot water/steam nozzle"
(page 16).
3. Make sure the milk intake tube is correctly inserted in the
bottom of the milk container lid (fig. 16).
4. replace the milk container lid and turn anticlockwise as
far as it will go.
5. remove the hot water spout from the nozzle (fig. 17).
6. attach the container to the nozzle and push as far as it
will go (fig. 18). The machine emits a beep (if the beep
function is active).
7. place a sufficiently large cup under the coffee spouts and
frothed milk spout.
To use particularly tall cups/glasses, raise the lid of the
compartment in the cup tray (fig. 19).
- froth
button (fig. 12).
button again to enable the

Making cappuccino

1. after attaching the milk container, position the container
pointer on 1 " CaPPuCCino" printed on the milk container
lid (fig. 20).
The quantity of froth can be adjusted during delivery by
moving the pointer slightly towards 2 "MaCChiaTo" for a
denser froth.
Moving it towards 1 "CaPPuCCino" obtains a less dense
froth.
2. Press the CaPPuCCino button (fig. 21). The message
"CaPPuCCino ConTainer PoinTer in PoSiTion 1"
appears. (after a few seconds, frothed milk flows out of
the milk spout into the cup below. Milk delivery stops
automatically and coffee delivery begins).
Please note:
if during delivery you want to stop making milk or coffee, press
the CAPPUCCINO button again.

Making macchiato

1. after attaching the milk container, position the container
pointer (B1) on 2 "laTTe MaCChiaTo" (fig. 22) printed on
the milk container lid.
2. Press the lATTE MACCHIATO button (fig. 23). The
message "laTTe MaCChiaTo ConTainer PoinTer in
PoSiTion 2" appears. after a few seconds, frothed milk
flows out of the milk spout into the cup below. Milk
delivery stops automatically and coffee delivery begins.
Please note:
if during delivery you want to stop making milk or coffee, press
the lATTE MACCHIATO button again.
Making caffelatte
1. after attaching the milk container, position the container
pointer on "3 CaFFelaTTe" (fig. 24) printed on the milk
container lid.
2. ress the CAFFElATTE button (fig. 25). The message
"CaFFelaTTe ConTainer PoinTer in PoSiTion 3" appears.
after a few seconds, milk is delivered from the milk spout
into the cup below. Milk delivery stops automatically and
coffee delivery begins.
Please note:
if during delivery you want to stop making milk or coffee, press
the CAFFElATTE button again.

Making frothed milk and hot milk (WITHOUT COFFEE)

1. after attaching the milk container, position the container
pointer (B1) according to the quantity of froth you require
(pos. 3 caffelatte = little froth; pos. 1 cappuccino = fuller
froth).
14