Troubleshooting - DèLonghi ESAM6600 Instructions For Use Manual

TROUBlESHOOTING

Below is a list of some of the possible malfunctions. if the problem cannot be resolved as dPribed, contact Customer Services.
PROBlEM
The coffee is not hot
The coffee is not creamy
enough.
The coffee is delivered too
slowly or a drop at a time.
The coffee does not come out
of the spouts, but from around
the service door.
The milk contains bubbles or
squirts out of the milk spout.
The milk is not frothed.
The appliance does not come
on.
The milk does not come out of
the milk spout.
POSSIBlE CAUSE
The cups were not preheated.
The infuser has cooled down because 2/3 minutes have
elapsed since the last coffee was made.
a low coffee temperature is set.
The coffee is ground too coarsely.
Wrong type of coffee
The coffee is ground too finely.
The holes in the spouts are clogged.
The coffee guide inside the service door is blocked.
The milk is not cold enough or is not semi-skimmed.
The milk container lid is dirty.
The hot water/steam nozzle is dirty
The milk container lid is dirty.
The hot water/steam nozzle is dirty
the frothed milk regulator is in the "CaFFelaTTe" position.
it is not plugged into the mains socket.
The main switch is not in position i.
The milk container lid is dirty.
REMEDY
Warm the cups by rinsing them with hot water (using the
hot water function).
Before making the coffee, heat the infuser using the rinse
button.
Set maximum coffee temperature in the menu
Turn the grinding adjustment knob one click anticlockwise
towards "1" while the coffee mill is in operation (fig.
8). Continue one click at a time until coffee delivery is
satisfactory. The effect is only visible after delivering 2
coffees (see the section: "adjusting the coffee mill" on
page 12).
use a type of coffee for espresso coffee makers.
Turn the grinding adjustment knob one click clockwise
towards "7" while the coffee mill is in operation (fig. 11).
Continue one click at a time until coffee delivery is
satisfactory. The effect is only visible after delivering 2
coffees (see the section: "adjusting the coffee mill" on
page 12).
Clean the spouts with a toothpick (fig. 29).
Thoroughly clean the coffee guide, particularly near the
hinges.
you should ideally use skimmed or semi-skimmed milk at
refrigerator temperature (about 5°C).
if the result is not as you wished, try changing brand
of milk.
Clean the milk container lid as dPribed in the section
"Cleaning the milk container" (page 16).
Clean the nozzle as dPribed in the section "Cleaning the hot
water/steam nozzle" (page 16).
Clean the milk container lid as dPribed in the section
"Cleaning the milk container" (page 16).
Clean the nozzle as dPribed in the section "Cleaning the
hot water/steam nozzle" (page 16).
Put the milk regulator in the "CaPPuCCino" position.
Plug into the mains socket.
Place the main switch in the i position (fig. 1).
Clean the milk container lid as dPribed in the section
"Cleaning the milk container" (page 16).
21