Table of Contents

Advertisement

Quick Links

De'Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.com

Advertisement

Table of Contents
loading

Summary of Contents for DèLonghi ECAM45.76X

  • Page 1 De’Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.com...
  • Page 2 ECAM45.76X COFFEE MAKER Instructions for use. Keep these instructions Visit www.delonghiregistration.com to register your product Visit www.delonghi.com for a list of service centers near you. ELECTRIC CHARACTERISTICS 120 V~ 60 Hz 1250 W MACHINE À CAFÉ Mode d’ e mploi . Conservez cette notice Visitez www.delonghiregistration.com pour...
  • Page 3 page 6 page 25 pàg. 46...
  • Page 5 1 0 0...
  • Page 7: Table Of Contents

    CONTENTS 9. MAKING CAPPUCCINOS AND MILK-BASED COFFEES ..........14 1. IMPORTANT SAFEGUARDS ......7 9.1 Filling and attaching the milk container ..14 1.1 Short cord instructions .........7 9.2 Adjusting the amount of froth .....14 2. INTRODUCTION ..........8 9.3 Making cappuccinos and milk-based coffees 2.1 Symbols used in these instructions ....8 automatically ..........14 2.2 Letters in brackets .........8...
  • Page 8: Important Safeguards

    1. IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following. • Read all instructions carefully. • Make sure the voltage of your electrical system corresponds to the voltage shown on the bottom of the machine.
  • Page 9: Introduction

    2. INTRODUCTION 3. DESCRIPTION Thank you for choosing the ECAM45760 automatic coffee and 3.1 Description of the appliance cappuccino maker. (page 3 - A ) We hope you enjoy using your new appliance. A1. Beans container lid Take a few minutes to read these instructions. A2.
  • Page 10: Description Of The Accessories

    3.3 Description of the accessories If the power socket does not match the plug on the appliance, have the socket replaced with a suitable type by a qualified (page 2 - C ) electrician. C1. “Total Hardness Test” indicator paper C2.
  • Page 11: Turning The Appliance On

    5. TURNING THE APPLIANCE ON To enable the function, proceed as follows: 1. Press the MENU/ESC button (B14) to enter the menu; Please note! 2. Press < (B4) or > (B8) (fig. 9) until “Rinsing” appears on Before turning the appliance on, make sure the main switch the display (B13);...
  • Page 12: Auto-Start

    7.6 Auto-start 4. Press the OK button to enable or disable the cup warmer (the message “Cup warmer Enabled” indicates that it is You can set the auto-start time in order to have the appliance active); ready at a certain time (for example in the morning) so you can 5.
  • Page 13: Setting The Language

    7.12 Setting the language how many times the water softener filter has been replaced. To modify the language of the display (B13), proceed as follows: 5. Press the MENU/ESC button twice to exit the menu. 1. Press the MENU/ESC button (B14) to enter the menu; 2.
  • Page 14: Adjusting The Coffee Mill

    8.4 Adjusting the coffee mill • While the machine is making coffee, delivery can be inter- rupted at any moment by pressing any button. The coffee mill is set by default to prepare coffee correctly and • At the end of delivery, to increase the quantity of coffee in should not require regulating initially.
  • Page 15: Making Long Coffee Using Pre-Ground Coffee

    8.9 Making LONG coffee using pre-ground coffee • For a denser more even froth, you must use skimmed or partially skimmed milk at refrigerator temperature (about Follow the instructions in points 1, 2, 3 and 4 of the section “8.7 5°C).
  • Page 16: Preparing "Milk Menu" Drinks

    4. After a few seconds, frothed milk is delivered from the milk 4. Turn the dial back to one of the froth selections. spout (D5) into the cup below. Then the machine automat- 5. Remove the milk container (D) and always clean the hot ically makes the coffee after delivering the milk.
  • Page 17: Delivering Hot Water And Steam

    7. Once the required quantity of coffee has been delivered 3. Press the button (B8). After a few seconds, the steam into the cup, press the OK button again. Coffee delivery to heat the liquid comes out of the cappuccino maker/hot stops.
  • Page 18: Cleaning

    11. CLEANING To clean (with the machine on): • Remove the drip tray (A12) (fig. 31), empty and clean. 11.1 Cleaning the machine • Empty the grounds container (A10) and clean thoroughly The following parts of the machine must be cleaned regularly: to remove all residues left on the bottom.
  • Page 19: Cleaning The Water Tank

    2. Remove all the residues with a vacuum cleaner (fig. 34). 4. Press the two coloured release buttons inwards and at the same time pull the infuser outwards (fig. 37); 11.6 Cleaning the water tank 5. Soak the infuser in water for about 5 minutes, then rinse under the tap.
  • Page 20: Cleaning The Milk Container

    11.10 Cleaning the milk container 12. DESCALING To keep the frother efficient, clean the milk container (D) every Descale the machine when the message “DESCALE” flashes on two days as described below: the display (B13). 1. Remove the lid (D2). Important! 2.
  • Page 21: Setting Water Hardness

    13.1 Measuring water hardness played and the descaling procedure begins. The descaler liquid comes out of the caffee spouts and hot water spout 1. Remove the “TOTAL HARDNESS TEST” indicator paper (C1) and a series of rinses and pauses is performed to remove from its pack (attached to the English instructions).
  • Page 22: Replacing The Filter

    14.2 Replacing the filter 3. To activate the filter, run tap water through the hole in the filter as shown in the figure until water comes out of the When “REPLACE FILTER” appears on the display (B13), after two openings at the side for more than a minute (fig. 47). months (see date indicator) or when the appliance has not been used for 3 weeks, you should replace the filter (C4): 0,5 L...
  • Page 23: Displayed Messages

    16. DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION FILL TANK Insufficient water in the tank (A16). Fill the tank with water and/or insert it cor- rectly, pushing it as far as it will go until it clicks into place. EMPTY GROUNDS CONTAINER The grounds container (A10) is full. Empty the grounds container and drip tray (A12), clean and replace (fig.
  • Page 24: Troubleshooting

    INSERT TANK The tank (A16) is not correctly in place. Insert the tank correctly and press as far as it will go. GENERAL ALARM The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as described in section “11. CLEANING”. If the message is still displayed after cleaning, con- tact a service centre.
  • Page 25 The coffee is delivered too slowly or a The coffee is ground too finely. Turn the grinding adjustment dial (A5) one drop at a time. click clockwise towards "7" while the coffee mill is in operation (fig. 14). Continue one click at a time until coffee delivery is satisfactory.

Table of Contents