Cleaning The Milk Container; Cleaning The Hot Water/Steam Nozzle; Descaling - DèLonghi ESAM6600 Instructions For Use Manual

6. use the brush (a22) to remove any coffee residues left in
the infuser housing, visible through the infuser door.
7. after cleaning, replace the infuser by sliding it onto the
internal support and pin at the bottom, then push the
PuSh symbol fully in until it clicks into place.
Please note!
8. once inserted, make sure the two red
buttons have snapped out.
9. replace the drip tray and waste coffee
container.
10. Close the service door.

Cleaning the milk container

Clean the milk container each time you prepare milk as dPribed
below:
1. Turn the milk container lid clockwise then remove it.
2. remove the milk spout and intake tube.
3. Wash all the
c o m p o n e n t s
thoroughly with
hot water and mild
washing-up liquid.
All components are
dishwasher safe,
placing them in the
top basket of the
dishwasher.
4. Make sure there are
no milk residues left
inside the holes.
5. Check that the intake
tube and spout are
not clogged with milk
residues.
6. replace the milk
If the infuser is difficult to insert,
you must first adapt it to the right
dimensions by pressing it
forcefully from the bottom and
top as shown in the figure.
spout and intake tube.
7. replace the lid on the milk container, turning it
anticlockwise to hook it in place.

Cleaning the hot water/steam nozzle

each time you prepare milk, clean the nozzle with a sponge to
remove milk residues from the gaskets (fig. 24).

DESCAlING

descale the machine when the message "descale" flashes on
the display.
Important!
descaler contains acids which may irritate the skin and eyes.
it is vital to respect the manufacturer's safety warnings given on
the descaler pack and the warnings relating to the procedure to
follow in the event of contact with the skin and eyes.
Please note!
use de'longhi descaler only. under no circumstances should
you use sulphamic or acetic based descalers. Their use
invalidates the guarantee.
Failure to descale the appliance as dPribed above also
invalidates the guarantee.
1. Turn the machine on.
2. enter the settings menu by pressing the P button.
3. Select by pressing the OK button.
"descaling Confirm?" is displayed. Press OK to enable the
function.
4. The message " Add descaler" " press OK" is displayed.
5. Before confirming, empty the water tank (a13).
Pour the descaler diluted with water (respecting the
proportions indicated on the descaler pack) into the water
tank.
Place an empty container with a minimum capacity of 1.5
litres under the hot water spout.
Important! Danger of burns
hot water containing acid flows out of the hot water spout.
avoid contact with splashes of water.
6. Confirm by pressing the OK button.
7. The message "descaling..." is displayed.
The descaling programme starts and the descaler liquid
comes out of the water spout. The descale programme
automatically performs a series of rinses and pauses to
remove limescale deposits from inside the machine.
After about 30 minutes, the message "rinsing FILL TANK!" is
displayed.
8. The appliance is now ready for rinsing through with clean
water.
remove the water tank, empty, rinse under running
17