Table of Contents
Advertisement
Customising the quantity
To change the quantity of coffee the appliance delivers
automatically into the cup, proceed as dPribed below.
-
press for a few seconds, then release the the
coffee) or
(long coffee) button, until the message
"PrograM QuanTiTy" is displayed and coffee delivery
commences;
-
when the coffee in the cup reaches the required level, press
the same button again to memorise the new amount. This
is confirmed by two beeps.
The appliance is now reprogrammed with the new settings and
the message "ready" is displayed.
Please note:
you can customise one cup coffee only: the double quantity is
automatically updated.
Adjusting the coffee mill
The coffee mill is set by default to prepare coffee correctly and
should not require regulating initially.
however, if after making the first few coffees you find that
delivery is either too fast or too slow (a drop at a time), this
can be corrected by adjusting the grinding adjustment knob
(fig. 10).
Please note!
The grinding adjustment knob must only be turned when the
coffee mill is in operation.
evident after at least 2 cups of coffee have been delivered.
if delivery is still too fast or too slow, repeat the correction,
turning the knob another click.
Tips for a hotter coffee
For a hotter coffee, you are recommended to:
•
before delivering the coffee, perform a rinsing cycle by
pressing the
button to select the "rinsing" function.
hot water is delivered from the spout, heating the internal
circuits of the appliance and thus raising the coffee
temperature.
•
place the cups on the cup warmer until they are warm.
(short
For faster delivery (not a drop
at a time), turn one click
clockwise towards "7" (coarser
ground coffee).
For fuller bodied creamier
coffee,
turn
one
click
anticlockwise towards "1"
(finer ground coffee).
These adjustments will only be
•
warm the cups by rinsing them with hot water (using the
hot water function).
•
set a higher coffee temperature in the menu.
Making coffee using coffee beans
Important!
do not use caramelised or candied coffee beans as they could
stick to the coffee mill and make it unusable.
1. Fill the container with coffee beans (fig. 8).
2. Place under the coffee spouts:
- 1 cup, if you want to make 1 coffee (fig. 9);
- 2 cups, if you want 2 coffees (fig. 10);
3. lower the spouts as near as possible to the cup. This makes
a creamier coffee (fig. 11).
4. Press the button corresponding to the number of coffees
required.
5. Preparation begins.
once the coffee has been made, the appliance prepares for use
again.
Please note:
•
While the machine is making coffee, delivery can be
interrupted at any moment by pressing one of the coffee
buttons.
•
at the end of delivery, to increase the quantity of coffee
in the cup, just press (within 3 seconds) one of the coffee
buttons.
once the coffee has been made, the appliance is ready to use
again.
Important!
if the coffee is delivered a drop at a time, too fast and not creamy
enough or too cold, read the tips in the "Troubleshooting"
section on page 19.
various alarm messages could be displayed while using the
machine. Their meaning is explained in the section "displayed
messages" (page 18).
Making coffee using pre-ground coffee
Important!
•
Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it. This could damage the appliance.
•
Never use more than one level
measure or it could dirty the inside
of the machine or block the funnel.
13
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
