Toshiba e-studio 450 Operator's Manual page 210

12.ERROR CODE (Cont.)
Error Code
2C65, 2C66,
2C69
2C67, 2C68
2C6A
2C6B
2C6C
2C6D
2C70
2C80
2C81
2CC0
9
2CC1
Save as file
2D10, 2D12,
2D13,
2D20-2D22
2D11
2D14, 2D61
2D15, 2D65
2D30
208
9.JOB STATUS
Cause & Message
Failed to connect to SMTP server
Failed to send E-Mail message
Invalid address specified in From: field
Invalid address specified in To: field
NIC system error
SMTP service is not available
Failed to process received E-mail job
Failed to process received Fax job
Job canceled
Power failure occurred
Illegal Job status
Not enough memory
Invalid parameter specified
There are too many documents in the
folder. Failed in creating new document.
Failed to create directory
Corrective Action
Make sure the SMTP server is correctly
working, or the SMTP server address has
been set correctly. Then retry the scan.
Turn the power OFF and then back ON. Retry
the scan. If the error still occurs, contact your
service representative.
Make sure that there is an illegal character in
the Terminal mail address. Delete the illegal
character and reset the appropriate Terminal
mail address, then retry it.
Make sure that there is an illegal character in
the Destination mail address. Delete the
illegal character and reset the appropriate
Destination mail address, then retry it.
Contact your dealer for support.
Ask your administrator whether the SMTP
service is enabled.
Ask your administrator to confirm whether the
Received Internet Fax Forward is set.
Ask your administrator to confirm whether the
Received Fax Forward is set.
(Job was canceled.)
Make sure that the power cable is connected
properly and it is inserted securely. Resend
the job.
Turn the power OFF and then back ON. Retry
sending. If the error still occurs, contact your
service representative.
Make sure there are enough memory to save
the scan job.
Make sure you specify the settings correctly
and try again.
Delete the data in the local shared folder in the
equipment and retry the scan.
Make sure that the access privilege to the
storage directory is writable and the server or
local disc has a sufficient space. Then retry
the scan.