Poor Fusing - Oki OKIPAGE 6e Service Manual

Poor Fusing

7
• Is paper of the specified grade being used?
• No
• Yes Is the spring of the back-up roller normal?
• No
• Yes Is the contact of the fusing unit assy in proper contact with the contact assy (see
Fig. 6-4
• No
• Yes Replace the fusing unit assy.
• Has the problem been removed?
• Yes
Note: After replacing the fusing unit assy, set the printer in the engine mainte-
• No Replace the Main Control PCB or power supply board.
Troubleshooting
Use paper of the specified grade.
Replace the spring.
)?
G
Adjust the contact of the fusing unit assy to make a proper contact with the
contact assembly.
End
nance mode by turning the power on while pressing the FORM FEED and
ENTER keys, and reset the fuser counter (see 4.1).
6 - 40
Service Manual, P/N 59276401
OKIPAGE 6e/6ex