Oki OKIPAGE 6e Service Manual page 230

3.3.6 Roller-A and B
While only the removal procedure for roller-A is described here, the removal procedure for roller-
B is basically same. When removing roller-B, however, be careful not to deform the sensor lever.
(1) Remove the upper frame (see 3.3.2 steps (1) through (3)).
(2) Remove the separator assembly (see 3.3.2).
(3) Remove the OLEV-11 PCB (see 3.3.3).
(4) Remove the motor bracket (see 3.3.5).
(5) Remove the gear 1.
(6) Shift the roller-A 2 to the right, lift it on its left side and slide it out (the bearing 3 also comes
off while you are doing this, so be careful not to lose it).
2
3
1
Sensor Lever
Roller-B
Multi-Purpose Feeder E - 13 OKIPAGE 6e/6ex
Service Manual, P/N 59276401