Oki OKIPAGE 6e Service Manual page 256

• ( JAM error )
Paper Inlet Jam
• Does paper jam at the inlet when the power is turned on?
• YES
• NO
• YES
• NO When the paper is fed in, does the paper inlet jam occur?
• YES
• NO
• NO Is the hopping roller shaft rotating?
• YES
• NO Is the stepping motor turning?
• YES
• NO Is the connector cable being connected properly?
• NO
• YES Check the coil resistance (approx. 32Ω) of the pulse motor.
Is is normal?
• NO
• YES Replace the OLEV-12 PCB.
Is the paper located above the sensor plate (Inlet)?
• YES Remove the paper.
Is the sensor plate (Inlet) operating normally?
• NO Replace the sensor plate (Inlet).
Replace the power supply board or inlet sensor.
Is the paper being fed to above sensor plate (Inlet)?
• YES Is the sensor plate (Inlet) operating normally?
• NO Replace the sensor plate. (Inlet)
• YES Clean the inlet sensor on the power supply board or replace the
power supply board or inlet sensor.
Replace the hopping roller shaft assy or paper cassette.
Set the paper properly.
Replace the one-way clutch gear on the hopping roller shaft assembly.
Connect the connector cable properly.
Replace the pulse motor.
F - 15 OKIPAGE 6e/6ex
Service Manual, P/N 59276401