Keyless Access Function - Subaru April BRZ Service Manual

2012
Table of Contents

Advertisement

PRE-DELIVERY INSPECTION
• Press the "PANIC" button of the keyless trans-
mitter. Check that the panic mode (the horn keeps
sounding) is initiated. Also, check that this condi-
tion continues for 30 seconds or until when any of
the buttons on the keyless transmitter are pressed.
• Momentarily press the "LOCK" button on the
keyless transmitter with one door open. Check that
the buzzer sounds to warn that the door is not fully
closed.
• Driver's side
• Passenger's side
Pre-delivery Inspection
Alarm sound operational check
• Models with the keyless access function use the
buzzer and sounds the alarm when the door is
locked or unlocked. The alarm sound can be turned
OFF. To turn the alarm sound from ON to OFF,
close all doors, (with the key not inserted in the key
cylinder), hold down the "UNLOCK" side of the
power door lock switch and insert the key in the key
cylinder. Within 10 seconds, insert and take out the
key for 5 times or more, and within 10 seconds after
that, open and close the driver's door. With the
door closed, the hazard light will flash 3 times, indi-
cating that the alarm sound has been turned OFF.
To turn the alarm sound from OFF to ON, perform
this procedure again. The hazard light will flash 3
PI-00784
times, indicating that the alarm has been turned
ON.

21.KEYLESS ACCESS FUNCTION

CAUTION:
• When performing the check, check one ac-
cess key at a time, separating individual keys.
• Do not leave any separated access keys in
the vehicle.
NOTE:
The following inspections show the initial settings.
When the settings are different from the initial set-
tings, use Subaru Select Monitor to check the de-
tails of each setting for inspections.
• While carrying the access key, check that the
room light illuminates when you move close to the
PI-00776
front door handles of the vehicle whose doors are
all locked.
• While carrying the access key, check that the
driver's door unlocks and the hazard lights flash by
grasping the driver's side front door knob (touching
the touch sensor).
• While carrying the access key, check that all
doors are unlocked and the hazard lights flash by
grasping the front passenger's door knob (touching
the touch sensor).
• While carrying the access key, check that all
doors are locked and the hazard lights flash when
PI-00779
touching the front door lock-touch sensor.
PI-10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents