Subaru April BRZ Service Manual page 23

(A)
(B)
(1) Push against the spool. (Insert the hose and
prevent it from becoming wrinkled.)
(2) Tighten the hose outwards and apply force thor-
oughly.
(A) Correct position (Spool base)
(B) Correct position (Spool top)
• Check if the position, direction and hose lay-
out of the hose clamp are correct. (Check if the
position, direction, length and the gap around
are correct, or if it is different from the condition
before the work)
• After the installation, check that the hose is in-
stalled securely and there is no leakage. (Check
if it is fixed securely with the clamp)
Precaution
• For hose clips and hose clamps, perform the
inspection below and replace them with a new
part if faulty.
• Check for deformation, rust, damage or for-
eign matters.
• For hose clip, check if it works and has clamp-
ing force.
• For hose clamp, check if it can tighten screw,
not ovalized or the screw is not damaged.
• For hose pipes, perform the inspection below
and replace with a new part if faulty.
Check if the pipe is not damaged, rusted, peeled
(peeled plates included), covered with foreign
matter, bent, compressed or cracked.
• For the parts below, replaces with a new part
when the hose is removed or the installation
position is changed.
ATF cooler hose, fuel hose (delivery)
PC-00080
PC-5
PRECAUTION