Tire; Fuse Installation; Dynamic Test With The Vehicle Running - Subaru April BRZ Service Manual

PRE-DELIVERY INSPECTION

Dynamic Test with the Vehicle Running

Step
50. Brake test
51. Parking brake
52. Shift control
53. Cruise control
Checks after Dynamic Test
Step
54. Fluid leakage
55. Water leak test
56. Appearance 2
1. APPEARANCE
• If the vehicle is covered with protective coating,
visually check the vehicle body for damage and
dents.
• When there is no protective coating, check the
body paints for damage or stains in detail and re-
pair as necessary.
• Check the window glass, door glass, and lights
for any cracks or damage, and replace as neces-
sary.
• Visually check the plated parts, such as the
grilles and door knobs, for damage or loss of gloss
and replace the parts as necessary.
• Check the instrument panel, console and trim for
stains or dirt.

2. TIRE

• Check the tires for damage, defective, and dents
on wheels.
• Check the tire size, spare tire and tire air pres-
sure described on the tire air pressure label (driv-
er's side).
Pre-delivery Inspection
Check the foot brake for normal operations.
Check the parking brake for normal operations.
Check that the shift patterns are correct.
Check that the cruise control system operates normally.
Check for fluid/oil leaks.
Spray the vehicle with water and check for water leaks.
1. Remove the protective coating (if equipped).
2. Check the body paints for damage and stain.
3. Check the plated parts for damage and rust.

3. FUSE INSTALLATION

The DCC (back-up) 30A fuse is moved from posi-
tion (A) to (B) as shown in the figure below to pre-
vent battery consumption when vehicles are
delivered. Remove the fuse from (B) and install in
(A) as shown in the figure below.
PI-4
Check point
Check point
(A) (B)
NT-00457