General Description; Pre-Delivery Inspection (Pdi) Procedure - Subaru April BRZ Service Manual

PRE-DELIVERY INSPECTION
1. Pre-delivery Inspection
A: GENERAL DESCRIPTION
The purposes of the pre-delivery inspection (PDI) are as follows.
• Remove the additional parts used for ensuring the vehicle quality during transportation and restore the ve-
hicle to its normal condition.
• Check the vehicle before delivery is in normal condition.
• Check the vehicle or parts for any damage occurred during transportation or storage.
• Check the vehicle after repair is in normal condition.
• Make sure to provide a complete vehicle to customer.
For above reasons, all SOAs (dealerships) must carry out the PDIs before delivery of vehicle.
Refer to this manual unless otherwise specified.
B: PRE-DELIVERY INSPECTION (PDI) PROCEDURE
Perform the procedures indicated in the table below.
Static Checks Just after Vehicle Receipt
Step
1. Appearance
2. Tire
3. Fuse installation
4. Door lock/unlock and open/close operations
5. Trunk lid open/close operations
6. Operation check of trunk lid release lever
7. Fuel lid opener lever
8. Towing hook (eyebolt)
9. Accessory
10. Front hood lock release
11. Battery
12. Brake fluid
Pre-delivery Inspection
1. If the vehicle is covered with protective coating, visually check the vehicle
body for damage and dents. If the protective coating has been removed,
visually check the painted body surfaces in detail for damage or rust.
2. Visually check the glass and light lenses for any damage, cracks or exces-
sive gaps between body sheet metal.
3. Visually check the plated parts for any damage.
4. Check the instrument panel, console and trim for stains or dirt.
1. Check the tires for damage, defective, and dents on wheels.
2. Check the tire air pressure.
If the vehicle is about to be delivered to customer, attach a DCC (back-up)
fuse.
1. Using the key, check the door can be locked or unlocked normally.
2. Open and close all doors to check that there are no problems.
3. Operate the power door lock switch to check that all doors are locked and
unlocked normally.
1. Using the key, check that the trunk lid can be locked or unlocked normally.
2. Operate the trunk opener button to check that the trunk opens normally.
3. Use the valet key to check that the lock cannot be released.
4. Open and close the trunk lid to check that there are no problems.
Operate the trunk lid release lever to check that the trunk lock is unlocked
normally.
Operate the fuel lid opener to check that the fuel filler lid can be unlocked
normally.
At factory shipment, the towing hook (eyebolt) is installed to the rear bumper.
Remove the towing hook (eyebolt), store it in the holder.
Check that the following accessories are equipped.
• Owner's manual
• Warranty booklet
• Maintenance note
• Spare key
• Key No. plate
• Jack
• Tool set
• Spare tire
• Towing hook
Operate the front hood lock release lever to check that the front hood opens
normally.
Check the battery for any abnormal conditions such as rust or traces of bat-
tery fluid leaks.
Check the brake fluid amount.
PI-2
Check point