Sharp UX-E800 Operation Manual page 185

Messages and Signals
INVALID DATA
LINE ERROR
LINE IS IN USE
MEMORY IS FULL
MEMORY PRINTING
NET ERROR
NO DATA
NO MESSAGES
NO # STORED
OFF HOOK
184
You have entered an e-mail address that is not in the
correct format. Correct the address and then press
M
the key.
Transmission or reception was not successful. Press
the STOP key to clear the message and then try
again. If the error persists, see Line Error on page
178.
An extension phone connected to the fax is being
used. Do not lift the fax's handset or attempt
transmission at this time, as this will interrupt the
conversation on the extension phone.
The memory is full. This may occur during fax
reception if too much data is received before the
pages can be printed out. If faxes have been received
to memory because printing is not possible (an
additional message will indicate the problem), resolve
the problem so that printing can continue (see
Substitute Reception to Memory on page 101). If you
are attempting to transmit from memory, see If the
memory becomes full on page 155.
The fax is preparing to or printing out a document
from memory.
An error occurred after your Internet fax connected to
your provider to send or receive e-mail. See
Problems sending or receiving e-mail on page 177.
This appears if you attempt to search for an
automatic dialling number when none have been
stored.
You had no messages when your Internet fax called
your provider to retrieve messages.
You have tried to dial or clear a Rapid Key or Speed
Dial number that hasn't been programmed (a full
number hasn't been assigned to it).
This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press the STOP key to clear the message.