Lopi Revere Owner's Manual page 32

32
3. Place the door retainer into the door shell as shown below.
4. Make sure the holes in the retainer line up with the holes on the shell then use a 5/16" nutdriver to
secure the shell with the two screws. Tighten until the door shell is snug against the retainer (do
not over-tighten).
WARNING: Do not use a power drill or driver to attach the screws.
The castings must be properly threaded and not stripped.
5. Attach the door
handle following the
directions to the right.
6. Replace the door on
the hinges and latch
the door.
© Travis Industries
Optional Equipment
Door Retainer
Door Shell
5/16" Nutdriver
100-01339
The indent on the door retainer slides into
the clip on the door shell (on both sides).
9/16" Wrench
4150520