JLG 1250AJP Troubleshooting Manual page 316

SECTION 5 - CALIBRATIONS
Step 9 - Position 9
The analyzer will read:
Swing turntable 180° - Technician must center turntable
over original end of chassis
5-316
Potential Calibration Failure Messages:
• DRIVE ORNT SW - control system must detect change
in state of the drive orientation switch. Visible through
D I A G N O S T I C S ? D R I V E ? D R V. O R I E N TAT I O N
SWITCH: XX (CLOSED or OPEN)
• LOAD PIN FAULT - load pin resultant force (V-FORCE.
on analyzer) not within 18,140 and 44,140 or load pin
cal moment not between 445,000 and 1,577,000. Visible
through DIAGNOSTICS ? LOAD PIN ? LOAD PIN
MOMENT VALUE: XXXX.
1250AJP 3128411