Appliance Setup; Remove Fixed Glass Assembly; Remove Shipping Materials; Clean The Appliance - Heat & Glo Crescent II Owner's Manual

Hide thumbs Also See for Crescent II:

Table of Contents

Appliance Setup

A. Remove Fixed Glass Assembly

See Section 14.F.

B. Remove Shipping Materials

Remove shipping materials from inside and underneath the

ﬁ rebox. A shipping bracket on the bottom front face must

be removed. Remove the screws and shipping bracket and

discard. See Figure 14.1.

Figure 14.1

C. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated

inside the ﬁ rebox or underneath in the control cavity.

D. Accessories

Install approved accessories per instructions included

with accessories. Contact your dealer for a list of ap-

proved accessories.

WARNING! Risk of Fire and Electric Shock! Use ONLY

Hearth & Home Technologies-approved optional acces-

sories with this appliance. Using non-listed accessories

could result in a safety hazard and will void the warranty.

SHIPPING

BRACKET

REMOVE (4) NUTS

AND SHIPPING BRACKET

Heat & Glo • Crescent II • 2083-902 Rev. U • 4/15

Table of Contents