Appliance Preparation; Securing And Leveling The Appliance - Heat & Glo Crescent II Owner's Manual

9 9

Appliance Preparation

A. Securing and Leveling the Appliance
WARNING! Risk of Fire! Prevent contact with:
• Sagging or loose insulation
• Insulation backing or plastic
• Framing and other combustible materials
Block openings into the chase to prevent entry of blown-
in insulation. Make sure insulation and other materials
are secured.
DO NOT notch the framing around the appliance
standoffs.
Failure to maintain air space clearance may cause
overheating and fi re.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
The diagram shows how to properly position, level, and
secure the appliance. See Figure 9.1. Nailing tabs are
provided to secure the appliance to the framing members.
NAILING TABS
BOTH SIDES
2 HOLES IN BASE FOR
MOUNTING TO FLOOR
Figure 9.1 Proper Positioning, Leveling and Securing
of Appliance
• Place the appliance into position.
• Level the appliance from side to side and front to back.
• Shim the appliance, as necessary. It is acceptable to use
wood shims.
• Remove two side screws from each nailing tab. See
Figure 9.2. Refasten nailing tabs to the appliance.
Note: Return bend on nailing tab faces back of unit.
• Keep nailing tabs fl ush with the framing.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs.
• Holes are also provided in appliance bottom to secure
appliance to fl oor.
30 Heat & Glo • Crescent II • 2083-902 Rev. U • 4/15
FRONT
VIEW
REMOVE
SCREWS (2)
NAILING
TAB
TOP
VIEW
DETAIL A
RETURN BEND FACES
THE BACK OF THE UNIT
Figure 9.2 Nailing Tabs
BACK
VIEW
REFASTEN
NAILING
TAB
SCREWS (2)