Facing Requirements - Heat & Glo Crescent II Owner's Manual

B. Facing Requirements
There are two options to fi nish the front facing on the
fi replace, outside fi t surround and inside fi t surround.
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specifi ed in
this manual. Overlapping materials could ignite and will
interfere with proper operation of doors and louvers.
• Facing and/or fi nishing materials must not interfere with
air fl ow through louvers, operation of louvers or doors,
or access for service.
• Facing and/or fi nishing materials must never overhang
into the glass opening.
• Observe all clearances when applying combustible
materials.
Outside Fit Surround
The outside fi t surround design is used for facing materials
less than 3/4 inch for combustibles, and less than one inch
for non-combustibles. The surround is designed to fi t fl ush on
fi nishing materials. Hearth & Home Technologies approved
cabinets or 1/2 inch fi nishing materials are recommended.
See Figure 13.3.
Adjust fi replace position if facing material is other than 1/2
inch thick.
NOTICE: For Outside Fit Surrounds
• Surface temperatures are hot around fi replace opening.
• Facing material fi nishes may discolor or peel if not suited
to temperatures above 200º F.
Figure 13.3 Outside Fit Surround
To cut the arch use the dimensions shown in Figure 13.4.
Heat & Glo • Crescent II • 2083-902 Rev. U • 4/15
Figure 13.4 Outside Facing Dimensions
Inside Fit Surround
The inside fi t surround design is used with fi nishing
materials greater than 3/4 inch for non-combustible
fi nishing. The surround is designed to set back on fi nishing
materials. See Figure 13.5.
Figure 13.5 Inside Fit Surround
To cut the arch use the dimensions shown in Figure 13.6.
Figure 13.6 Inside Facing Dimensions
30-7/16 IN.
22-7/8 IN.
30-13/16 IN.
23-5/8 IN.
43