Controls - Raymarine gs series Installation Instructions Manual

6.2 Controls

1
Descrip-
tion Functions
1 Touch-
Touch the screen to operate functions,
screen
including all menu operations.
2 Power • Press once to switch the unit on.
• When powered on, press the Power
button again open the Shortcuts page.
• When powered on, press and hold to
put the display into Standby mode.
• If an integrated pilot is engaged, press
and hold to put the autopilot into
STANDBY mode.
3 Card Open the card door to insert or remove
reader a MicroSD card. There are 2 card slots
(labelled 1 and 2), used for electronic
charts and archiving waypoint, route, track
and settings data.
Keypad controls
Connecting the keypad allows you to control your
multifunction display remotely.
1 2
3
4
6
5
7 8
9 10
1. Home — press to return to the Homescreen.
2. Menu — accesses menus. Press again to close
menus.
3. UniControl — provides a rotary control and a
joystick with an OK push button for using menus
and applications.
4. Back — press to return to a previous menu or
dialog level.
5. Range Out — press to range out.
6. Range In — press to range in.
Getting started
2 3
9 5 6 1 2
11 10 7 8 3 4
7. Switch Active — press to switch the active
pane, or to switch the active multifunction display
(in multiple display systems).
8. WPT / MOB — press and release to access
the waypoint options. Press again to place
a waypoint. Press and hold to place a Man
Overboard (MOB) marker at your current
position.
9. Standby (Auto) — press to disengage
integrated autopilot, press and hold to activate
Auto mode on integrated autopilot.
10. Power — see table below:
Configura- Display
tion State
D12701-1
1 Off / Standby * Power on
Multifunction
On
display
Multiple All displays
multifunction Off or in
displays Standby
All displays
On
1 Display
On and 1
display Off
or in Standby
Note: * Only applicable to gS Series displays.
a Series, c Series and e Series displays cannot
be powered on using the keypad.
Note: In a multiple display configuration,
where displays are in different states, displays
that are turned off can only be turned on using
the Power button on the display.
11. Joystick Up direction.
D1271 1-1
Momentary Press and
press hold
—
Open Power off
shortcuts / put into
page Standby
—
* Power on
all displays
Power down
Open
all displays
shortcuts
page on
active display
Power down
Open
active display
shortcuts
page on
active display
65