Hd-Sdi Connection (Gs195) - Raymarine gs series Installation Instructions Manual

For further information regarding camera installation
(including power connection and mounting), refer to
the installation instructions supplied with the camera.
IP camera guidance
Raymarine ® MFDs are capable of displaying IP
camera feeds. Whilst third-party IP cameras may
work, Raymarine ® highly recommends only using
Raymarine ® IP cameras such as the CAM200IP.
As guidance any third-party IP camera must conform
to the following:
• The camera must support H.264 compression and
RTSP (Real time Streaming Protocol).
• The camera must be ONVIF compliant
• The camera must be capable of and be setup to
allow unauthenticated anonymous access
• The camera must be capable of and be setup to
assign an IP address automatically via DHCP
• The camera resolution must be set to no higher
than 720p
The camera settings must be checked and if
necessary adjusted using a PC and the software
supplied with the camera, prior to adding the camera
to the SeaTalk hs network.
Important: Raymarine
compatibility with third-party IP cameras.
Cables and connections
® does not guarantee

4.24 HD-SDI connection (gS195)

The gS195 includes a High Definition Serial Digital
Interface (HD-SDI), which can be used to view a
compatible video source using the multifunction
display's Camera application.
1
1. HD-SDI camera
2. HD-SDI input data cable
3. gS195 multifunction display
Note: If your camera or external display do not
have a standard BNC connection then a third party
adaptor and / or converter may be required.
The HD-SDI interface connections use BNC
connectors. It is recommended that Belden
1694A cable (not supplied) and the supplied BNC
connectors should be used to create the data
cables required for connecting the camera to the
multifunction display.
HD-SDI camera connection
The supplied BNC connectors and boot kit should
be used when connecting a camera using the units
HD-SDI interface.
When making the data cables the cable should be
fed through the boot first before attaching the BNC
connector to the end of the cable. It may be possible
to push the boot over the BNC connector and onto
the cable, however care must be taken not to split
the protective boot.
HD-SDI connection
1. 75 ohm BNC connector (Supplied)
2. Boot (Supplied)
3. Data cable (not supplied)
2
1 2
D13045-2
3
D13046-3
49