Baffl E Removal; Snap Disc Replacement - Quadra-Fire 21M-ACC Owner's Manual

E. Baffl e Removal
1. Remove all ash from the fi rebox, and extinguish all hot
embers before disposal into a metal container.
2. The baffl e board has 2 pieces. With the ceramic blanket
still in place, slide one baffl e piece over the top of other one
and pull out top piece through the door opening and then
remove bottom baffl e piece. Figure 31.1.
3. Remove the ceramic blanket.
4. Re-install the baffl e pieces one piece at a time. Be sure
the baffl e boards are even with the front manifold tube and
is resting on all tubes. Figure 23.1 on page 23. See Also
Correct Blanket & Baffl e Position on page 24.
5. To re-install the ceramic blanket, it is easier to fold it in half
fi rst. Figure 31.2. Place on top of baffl e board, open up
and fl atten and smooth out the blanket. Re-check the baffl e
board for correct positioning. Figure 23.1 on page 23 and
page 24.
Figure 31.1 - Baffl e
Figure 31.2 - Ceramic Blanket
October 13, 2015
2100 Millennium Wood Stove (ACC)
F. Snap Disc Replacement
1. Locate the snap disc bracket assembly at the bottom left
rear corner of the stove. Figure 31. 3.
2. A magnet holds the bracket to the stove. Pull the bracket
down away from the stove to expose the snap disc.
3. Pull the snap disc and spade connectors up and out of
bracket as shown in Figure 31.4.
4. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
5. Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the stove.
Snap Disc Location
Figure 31.3
Magnet
Figure 31.4
7039-131M
Snap Disc
Spade
Connectors
Page 31