Tube Channel Replacement - Quadra-Fire 21M-ACC Owner's Manual

2100 Millennium Wood Stove (ACC)
G. Tube Channel Assembly Replacement
Removing Tube Channel Assembly
1. Remove the right side shield by removing 2 screws in the
back using a Phillips head screw driver.
2. Remove 4 screws from channel access cover and remove
cover.
3. Locate 2 channel nuts inside of chamber and remove
using a 7/16 socket wrench. Slide out tube channel
assembly.
NOTE: Soak the bolts with penetrating oil for at least 15 min-
utes before trying to remove them.
Replacing Tube Channel Assembly
1. Slide one gasket on each tube fi rst
2. Slide the tube channel assembly into side of fi rebox and
insert each tube into the corresponding hole in the tube
channel rack starting with the back hole fi rst.
3. Make sure tube channel assembly is fl ush against the
side of the stove and secure with channel nuts.
4. Re-install channel cover and side shield.
Tube Channel Rack
Figure 32.1
Page 32
Slide one gasket
over each tube
Channel
Access
Cover
7039-131M
NOTE: Service Space
In order to replace the tube channel assembly a clear-
ance of 17 inches (432mm) is required on the right side
of stove in order to remove the tubes with the stove in
place.
If space is not available, the stove will have to be dis-
connected from the chimney to proceed with the tube
replacement.
Channel Cover
Screws (4)
Channel
Nuts (2)
Tube Channel
Assembly
Remove
2 Screws
Side Panel
October 13, 2015