Baffl E Removal; Firebrick Replacement; Door Handle Assembly - Quadra-Fire 57ST-ACC Owner's Manual

5700 STEP TOP ACC
C. Baffl e Removal
1. Remove all ash from the fi rebox, and extinguish all hot
embers before disposal into a metal container.
2. The baffl e board has 2 pieces. With the ceramic blanket
still in place, slide one baffl e piece over the top of other
one and pull out top piece through the door opening and
then remove bottom baffl e piece. Figure 20.1.
3. Remove the ceramic blanket.
4. Re-install the ceramic blanket and smooth out the blanket.
4. Slide the baffl e pieces one piece at a time underneath the
blanket. Be sure the baffl e boards are even with the front
manifold tube and is resting on all tubes. Figures 20.1 and
20.2.
Figure 20.1
Baffle Board & Blanket even
with front tube & resting on all
tubes
Ceramic Blanket on Top
Tube Channels
Figure 20.2
20
Burn Rate
Air Control
Start-Up
Air
Control
2 pc Baffle Board
D. Firebrick Replacement
Replace the fi rebrick if they become crumbly and/or if there
is a 1/4 inch (6.35mm) gap between the bricks.
Inspect the fi rebrick after each ash removal.
The fi rebox is lined with high quality fi rebrick, which has
exceptional insulating properties. There is no need to use a
grate; simply build a fi re on the fi rebox fl oor. Do not operate
appliance without fi rebrick.
1. After the coals have completely cooled, remove all old
brick and ash from unit and vacuum fi rebox.
2. Remove new brick set from box and lay out to diagram
shown.
3. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks. Slide
top of bricks under clip on back of fi rebox wall and push
bottom of brick back.
5. Install side bricks. Slide top of brick under clips on side
of fi rebox and push the bottom of the brick until it is fl ush
with the side of the appliance.
Use Part 832-0550 when ordering individual brick. Provide brick
dimension from the service parts list at the end of this manual , mark
the desired brick and take it to your authorized dealer.
E. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install second washer(s) as shown in Figure 20.3.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam over
shaft
6. Install locknut but do not overtighten, the handle needs
to move smoothly.
7. Install spring handle turning in a counter-clockwise
motion to desired location on door handle rod. Figure
20.3.
Do not overtighten lock nut. The door handle needs to
move smoothly.
).
atch am
ocknut
Figure 20.3
7038-207E
CAUTION
oor ross Section
(example)
oor andle
Spacing
Washers
S uare ey
February 25, 2016
Spring
andle