Table of Contents
Advertisement
2. Remove the front panel and rear
access panel.
3. Pull or block the tub in the direction
of the spring to be removed. Place
the round end of the tool against the
base of the unit and extend the
spring.
NOTE:
Removing the tub top will allow
the tub to travel further and extend the
spring even more.
4. Spring replacement is a reversal of
the above.
NOTE:
Be sure to grease the friction
points of the replacement springs before
installing.
16007667
IMPORTANT
No attempt should be made to
remove or install the springs with
pliers, vise-grips or anything other
than the spring tool, as damage to
the springs will probably occur.
When attaching the springs to the
base for installation, make sure the
spring end is protruding up
through the small triangular cut
out next to the debass.
o
SPRING TOOL KIT
PART NUMBER 21001138
SECTION 5. SUSPENSION SYSTEM
5·3
©
1996 Maytag Corporation
Advertisement
Table of Contents
