Table of Contents
Advertisement
7. The twist mount switches require no
screws to attach them to the control
shield. Instead, the tabs formed on
the face of the switch are inserted
into specially formed cutouts in the
control shield, then the rear of
the switch is rotated clockwise. This
allows a spring tab, located on the
switch, to interlock into a mating
cut-out in the control shield and
secures the switch to the shield.
Switch removal is accomplished by
disengaging the switch locking tab
from the control shield cut-out, and
rotating the rear of the switch in a
counterclockwise direction.
16007667
SECTION 3. CABINET ASSEMBLY COMPONENTS
3·5
©
1996 Maytag Corporation
Advertisement
Table of Contents
