Table of Contents
Advertisement
TOP ASSEMBLY
Raising the top will allow access to:
The top assembly consists ofthe top
panel, clothes door assembly, safety spin
switch and bracket, water inlet flume,
insulating grommet, bleach dispenser
(some models), and the control panel
assembly.
The assembly is mounted to the cabinet
with two (2) steel hinges which are at-
tached to the upper cabinet rear by two
(2) screws. These hinges fit into slots
located in the back edge of the top panel
which allows the top assembly to be
raised for servicing.
Two (2) holes pierced into the front flange
of the top assembly align with two (2)
locating pins to center the top assembly
to the cabinet. Two (2) spring clips en-
gage the top panel flange and secure the
top assembly to the cabinet front.
• Door Hinge Mounting Screws
• Flume and Inlet Hose
• Safety Spin Switch
• Air Bell Hose Connection
• Control Panel Mounting Screws
• Power Cord/Harness Connection
• Water Inlet Valve Wiring
• Pressure Switch Hose Clamp
• Agitator
• Basket Assembly
To raise the top assembly, insert a thin
bladed tool (such as a putty knife) be-
tween the front panel and top assembly
approximately four (4) inches in from
each corner. Depress each spring clip
while raising the top assembly.
REMOVAL:
NOTE: The locating pins and top clips
are mounted
to
the front panel flange on
all the models. (See the following fig-
ure).
1. Disconnect the unit from the power
source.
2. Raise the top assembly and remove
the flume inlet hose.
4. Disconnect the pressure switch hose
and all necessary wiring. Feed the
hose and wiring through their respec-
tive top holes.
3. Lower top and remove the control
panel rear shield .
5. Raise the top assembly slightly
while pulling forward to remove .
Cabinet Top Clip
/ '
.....
fer"
~~
·
.
Locating
Pin
·
·
.
.
•
•
.
.
·
·
....:.
.:....,
.
0
\.
~
16007667
SECTION 3. CABINET ASSEMBLY COMPONENTS
3·3
©
1996 Maytag Corporation
Advertisement
Table of Contents
