Table of Contents
Advertisement
Rock Washer
With Hands
~~
0
,
1
Make Sure Rear Feet
Move Freely Up and Down
• Place washer in final location.
Front foot adjustment for side to side
leveling - Loosen the locknut, making
sure it turns freely on the threads.
• When the machine is in place, screw
front feet out of base against the
floor until the machine is acceptably
level across the front.
8. Place the gooseneck end of the drain
hose into the standpipe or laundry
tub. The drain hose should fit loosely
in the standpipe to prevent siphoning.
(An anti-siphon valve and associated
parts are available from your dealer,
part number 33-4260).
• While holding foot still, turn the ad-
justing locknut clockwise until the nut
is tightened firmly against base.
NOTE: BE SURE THE DRAIN HOSE
IS NOT TWISTED OR KINKED.
LOCkN~--=7
---¥-Le
g
F o o t - - - U
T
32"
Min.
60"
Max.
1
Tilt machine forward until rear of cabi-
net is approximately 4 inches off the
floor, then lower the machine back to
the floor on the rear feet. This operation
will cause the rear stabilizing feet to
conform to the contour of the floor and
seat them solidly. Rock washer with
hands on opposite corners to check
stability.
9. Insert the screens and washers (pro-
vided in the parts envelope) into the
remaining ends of the water hoses.
Attach the water hoses to the hot
and cold faucets. BE SURE HOT
WATER INLET IS CONNECTED TO
HOT WATER FAUCET. Tighten by
hand until snug, and then a 2/3 turn
with pliers.
16007667
SECTION 1. INSTALLATION
1-4
©
1996 Maytag Corporation
Advertisement
Table of Contents
