Table of Contents
Advertisement
Top Locator
Pins
Front panel removal will allow access to
the:
• Motor
• Motor Mount
• Motor Wiring
• Motor Pivot Spring
• Front Suspension Spring
• Tub Brace
Removal:
1. Disconnect the unit from the
power source.
2. Insert a thin bladed tool between
the front panel and the top assem-
bly, approximately four (4) inches
in from each corner. While lifting
up on the top assembly, press the
blade against the wire clips,
one side at a time to disengage
them.
3. After raising the top assembly,
remove the two
(2)
screws which
attach the front panel to the
cabinet brace.
4.
Tip front panel back to clear the
locating pins on the cabinet front
flanges. Lift the panel up and
off the two
(2)
base mounting
clips.
Rear
Access
Panel
The access panel is constructed of enam-
eled steel and is attached to the cabinet
rear by eight (8) hex head screws.
Panel removal will allow access to the:
• Stabilizer Assembly
• Water Mixing Valve
• Pump Assembly
• Rear and Side Suspension Springs
• Tub Braces
• "J"
Bolts
16007667
SECTION 3. CABINET ASSEMBLY COMPONENTS
3-2
©
1996 Maytag Corporation
Advertisement
Table of Contents
