Configure The Tsr-302; Rf Setup; Single Gateway Setup - Crestron TSR-302 Supplemental Manual

Configure the TSR-302

RF Setup

On the main screen, tap RF Setup to display the RF Setup screen.
RF Setup Screen
The RF Setup screen shows the RF signal strength and has controls for enabling or
disabling roaming.
Before a TSR-302 can be used with a Crestron control system, it must first be acquired by
a Crestron Extended Range (RF) Wireless Gateway (sold separately).

Single Gateway Setup

When roaming is not enabled, i.e., a single gateway is used, there is a Single Gateway
Setup button at the bottom of the screen.
To acquire a TSR-302, perform the following procedure:
1. Use a stylus or other thin-tipped object to press ACQUIRE on the gateway to enter
2. Place the TSR-302 in Acquire mode by tapping Acquire on the RF Setup screen.
Supplemental Guide – DOC. 7663B
Acquire mode. The accompanying LED illuminates, indicating the unit is ready to
link with the touch screen. (The gateway can also be put into Acquire mode via
Crestron Toolbox.)
The screen displays an "Acquire in progress" message, and the TSR-302 is
automatically acquired by the gateway within 2 minutes.
TSR-302: Handheld Touch Screen Remote • 3