Installing An Hp Smart Storage Battery - HP ProLiant DL180 Gen9 User Manual

If you installed a cache module on the storage controller, connect the cache module backup power
10.
cable to the riser board.
Connect the other end of the storage controller cables to the drive backplane. For internal drive cabling
11.
information, see "Storage cabling (on page 113)."
If you are planning to install an HP Smart Storage Battery Pack, install it now
12.
Storage Battery" on page 71).
Install the access panel (on page 26).
13.
Do one of the following:
14.
Slide the server into the rack.
o
Install the server into the rack
o
Power up the server (on page 20).
15.
If you are planning to install new drives, install them now
16.
For more information about the integrated storage controller and its features, select the relevant user
documentation on the HP website (http://www.hp.com/go/smartstorage/docs).
To configure arrays, see the HP Smart Storage Administrator User Guide on the HP website
(http://www.hp.com/go/smartstorage/docs).

Installing an HP Smart Storage Battery

For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP website (http://www.hp.com/go/qs).
CAUTION:
powered down and the last to be powered back up. Taking this precaution ensures that the system
does not erroneously mark the external drives as failed when the server is powered up.
To install the component:
Power down the server (on page 20).
1.
Remove all power:
2.
("Installing the server into the
In systems that use external data storage, be sure that the server is the first unit to be
("Installing an HP Smart
rack" on page 36).
("Drive options" on page 43).
Hardware options installation 71