Setting Up Monitoring Using Snmp - Epson EB-U32 User Manual

Setting Up Monitoring Using SNMP

Network administrators can install SNMP (Simple Network Management
Protocol) software on network computers so they can monitor projectors. If
your network uses this software, you can set up the projector for SNMP
monitoring.
a
Press the [Menu] button on the control panel or remote control.
b
Select the Network menu and press [Enter].
c
Select Network Configuration and press [Enter].
d
Select the Others menu and press [Enter].
e
Set the SNMP setting to On.
f
Enter up to two IP addresses to receive SNMP notifications, using 0 to
255 for each address field.
Do not use these addresses: 127.x.x.x or 224.0.0.0 through
a
255.255.255.255 (where x is a number from 0 to 255).
g
When you have finished selecting settings, select Complete and follow
the on-screen instructions to save your settings and exit the menus.
95