Models - Intermec EasyCoder PD41 Service Manual

Chapter 2 — Models and Options

Models

12
The EasyCoder PD41/PD42 printer is available with a 200 or 300 dpi
printhead. The label taken sensor is installed into all printers. The Real
Time Clock module is in the PD42 only and is supported by the
Fingerprint firmware.
The PD42 is best described as an enhanced version of the PD41, which
comes equipped with a display, larger memory, real time clock, and a USB
host interface as a standard. The dimensions of the two printers are
identical.
All models ship with either Fingerprint or IPL firmware pre-installed.
Note: All error messages in this version of the service manual relate to
Fingerprint. IPL specific error messages are not covered in this manual.
EasyCoder PD41 printer
EasyCoder PD41/PD42 Printer Service Manual