Email Alerting And Mail Server Commands; Logging Persistent; Logging Email - NETGEAR M4100 Series ProSAFE Reference Manual

Term Definition
Number of Traps The number of traps since the last boot.
Since Last Reset
Trap Log The number of traps the system can retain.
Capacity
Number of Traps The number of new traps since the command was last executed.
Since Log Last
Viewed
Log The log number.
System Time Up How long the system had been running at the time the trap was sent.
Trap The text of the trap message.

logging persistent

Use this command to configure the persistent logging for the switch. You can specify the
<severitylevel> value as either an integer from 0 to 7 or symbolically through one of the
following keywords: emergency (0), alert (1), critical (2), error (3), warning (4),
notice (5), info (6), or debug (7).
Default Disable
Format
logging persistent <severitylevel>
Mode Global Config
no logging persistent
Use this command to disable the persistent logging in the switch.
Format
no logging persistent
Mode Global Config

Email Alerting and Mail Server Commands

logging email

This command enables email alerting and sets the lowest severity level for which log
messages are emailed. If you specify a severity level, log messages at or above this severity
level, but below the urgent severity level, are emailed in a non-urgent manner by collecting
them together until the log time expires. You can specify the <severitylevel> value as
either an integer from 0 to 7 or symbolically through one of the following keywords:
emergency (0), alert (1), critical (2), error (3), warning (4), notice (5), info (6),
or debug (7).
M4100 Series ProSAFE Managed Switches
Utility Commands
358