Spanning-Tree Configuration Name; Spanning-Tree Configuration Revision; Spanning-Tree Edgeport - NETGEAR M4100 Series ProSAFE Reference Manual

spanning-tree configuration name

This command sets the Configuration Identifier Name for use in identifying the configuration
that this switch is currently using. The <name> is a string of up to 32 characters.
Default base MAC address in hexadecimal notation
Format
spanning-tree configuration name <name>
Mode Global Config
no spanning-tree configuration name
This command resets the Configuration Identifier Name to its default.
Format
no spanning-tree configuration name
Mode Global Config

spanning-tree configuration revision

This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The Configuration Identifier Revision Level is
a number in the range of 0–65535.
Default 0
Format
spanning-tree configuration revision <0-65535>
Mode Global Config
no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using to the default value.
Format
no spanning-tree configuration revision
Mode Global Config

spanning-tree edgeport

This command specifies that this port is an Edge Port within the Common and Internal
Spanning Tree. This allows this port to transition to Forwarding State without delay.
Default Enabled
Format
spanning-tree edgeport
Mode Interface Config
M4100 Series ProSAFE Managed Switches
Switching Commands
30