Completing The Installation; Installing The Server Cover And Bezel; Updating Your Server Configuration - IBM Xseries 345 8670 Maintenance Manual

10. Connect all external cables and all power cords.
11. Reinstall the server cover (see "Installing the server cover and bezel").
12. Start the Configuration/Setup Utility program and set configuration parameters

Completing the installation

To complete your installation, reinstall the bezel, reinstall the server cover,
reconnect all cables that you disconnected earlier, and for certain options, run the
Configuration/Setup Utility program. Follow the instructions in this section.
Attention:
v For proper cooling and airflow, replace the server cover before or shortly after
v To ensure proper server operation, do not remove the air-baffle assembly from

Installing the server cover and bezel

The following illustration shows how to install the server cover and bezel.
Complete the following steps to install the server cover:
1. Place the cover-release latch in the open (up) position.
2. Insert the bottom tabs of the left-side cover into the matching slots in the server
3. Press down on the cover-release latch to lock the cover in place.
Complete the following steps to install the bezel:
1. Align the hooks on the bottom of the trim bezel with the server.
2. Press the bezel toward the server until it clicks into place.

Updating your server configuration

When you start your server for the first time after you add or remove an internal
option or an external SCSI device, you might see a message telling you that the
configuration has changed. The Configuration/Setup Utility program automatically
as needed. See Chapter 2, "Configuring your server", on page 9 for additional
information about using the Configuration/Setup Utility program.
turning on the server. Operating the server for extended periods of time (over 30
minutes) with the server cover removed might damage server components.
the server except when installing or removing the components that are located
under the air baffle.
Bezel
chassis.
Cover-release latch
Chapter 4. Customer replaceable units
71